Jets

Touch the “Jets” button to turn the main 2-speed pump on or off, and to shift between low and high speeds. If left running, the low speed of the pump will automatically turn off after 2 hours, and the high speed will automatically turn off after 15 minutes.

Boost

The “Boost” button will operate the blower pump, if equipped, or the 1-speed pump.

Lights

Press the Light button on the topside control panel to turn the spa light on. If your spa has perimeter LED lights, they will also light up at the same time as the spa light. LEDs operate in four modes. The mode is changed by turning the light off and then immediately back on

1. Fading: The lights will cycle through all the colors in this order: White, Cyan, Magenta, Blue, Chartreuse, Green, Red

2. Color Locked: This cycle offers a hard color change without fading.

3. Quick Color Change: Each time you press the button, you advance to the next color.

4. Flashing white: The LED lights will flash white.

“Temp”

To display the Set Temperature, press the “Temp” button once. The LCD will begin to flash the set temperature. To change the set temperature press the “Temp” button again prior to the flashing timing out. The temperature will go either up or down. To change the temperature in the opposite direction wait for the LCD to stop flashing. Press the “Temp” button again to resume the LCD flashing screen, and then press the “Temp” button. Once at the desired temperature, allow a few seconds for the flashing to cease. Your Set Temperature has now been set.